Dial Alert

The Dial Alert is a device that you can place in your home or office which will automatically dial up to nine pre programmed phone or pager numbers of your choice in the event of a problem.

The Dial Alert can be activated by several different accessory sensors. When activated the Dial Alert will play a 40 second personalized message for each of the numbers you have programmed. There is also an entrance and exit delay of up to 75 seconds that will give you time to deactivate the dialer before it calls. The Dial Alert also has a Battery backup so a power failure will not interrupt the performance..

Wireless PIR Sensor

This is a wireless passive infrared sensor that will send a signal to the Dial Alert whenever an intruder breaks into an unauthorized area. This unit detects body motion. It covers an area approximately 30' by 30'. Several transmitters can be used in different locations. The transmitter
operates on a 9 volt battery.

Wireless Panic Button

This wireless panic button, which may be worn on a chain around the neck or carried in your pocket, is ideal for older people who live alone or those with health problems. It also serves in applications such as 24 hour convenience stores where employees could use limited security late at night. In the event of a problem, press the small button on the panic button and it will automatically send a radio signal to the Dial Alert which will immediately dial out to summon help.

*Actual range will vary depending on the local terrain.

The temperature alert sensor detects a temperature rise or drop. This unit works well used in conjunction with our telephone dialer to monitor homes, stores, outbuildings, etc. when you are away.
In the event of heat rise or loss, the sensor will activate the Dial Alert to alert the proper parties. The sensor's range is from 0 degrees to 150 F and may be adjusted to the high and low temperatures you require.

The wireless door contacts can be mounted on any door and will activate the Dial Alert when the door is opened. The contacts, which run on one 12 volt alkaline battery, work well with the dialer because they can make full use of the entry and exit delay on the dialer..

Place the flood sensor in the basement or utility room near a sump pump, water heater or washing machine. If water is detected the Flood Sensor will send a signal to the Dial Alert to notify the proper party that there is a problem at your location. The Flood Sensor will help minimize any aggravation caused by leaking or broken pipes.

Copyright © 2003 Dakota Alert. All rights reserved.

At Dakota Alert, we have been distributing and manufacturing driveway alarms for over 20 years. We have the experience necessary to meet your needs. Our product lines include Wireless Motion Drive Alerts, Wireless Rubber hose drive alerts, Vehicle Sensors, Weather Alert products and much more. Wireless Motion Alerts are very popular units because they are easy to install and will detect both vehicles and people walking. The radio operated drive alert consists of 2 parts - a transmitter and a receiver with 1 whistle. The receiver can be located in your house and plugged into a standard wall outlet. The weatherproof outside transmitter, operated by a 9 volt battery that normally lasts 6 months to 1 year, should be located in the area of your driveway. The transmitter sends out an invisible beam approximately 80 feet. The beam may be pointed in any direction since there is no reflector needed at the end of the beam. If a vehicle or person enters this area, the transmitter, which detects motion will send a radio signal up to 1000’* back to the receiver in the house. This sounds a small whistle for approximately 3 seconds to alert you and then shuts off automatically. In the event that you do not want the whistle to sound at any particular time, the receiver is equiped with an on-off switch.