Wireless Rubber Hose Alert 3000

The WRH-3000 is a very reliable and easy to install driveway alarm. The transmitter operates on one 9-volt battery and has 25' of 3/8" diameter exterior hose that will lie across the drive. When a vehicle drives over the hose, a signal will be sent to the WR-3000 receiver up to 3,000 feet away*.
The transmitter is weatherproof and meant for exterior locations. Up to 4 zones can be monitored with additional transmitters. The transmitters can be programmed so they will each sound a diff erent tone at the receiver.

The WR-3000 is the receiver for the WRH-3000 system. The WR-3000 plugs into a standard wall outlet and can be placed on a table or mounted on the wall. When the receiver gets a signal from the transmitter, one of four diff erent tones (Classical, Westminster Chime, Ding Dong, or Whistle) will sound for a few seconds. There is also a volume control, allowing you to set the sound to the desired level. The WR-3000 is equipped with four form “C” relays (one for each zone), and one 12-volt DC output terminal that will activate for several seconds when a signal is received. The receiver can be user-programmed, so the 12-volt DC terminal and one relay will activate
for 10 minutes, if this is desired. The tones will still sound for several seconds.

Extra Rubber Hose Transmitter

Extra wireless transmitters can be used in other locations; for example, 2 driveways. Comes complete with transmitter and 25' Hose.

Extra Receiver

The receivers can be placed in other buildings or locations, and will sound at the same time.

*Actual range will vary depending on the local terrain.

50 cents per foot. The rubber hose transmitter comes standard with 25' of hose. Extra hose up to a total of 200' can be used on a transmitter.

Copyright © 2003 Dakota Alert. All rights reserved.

At Dakota Alert, we have been distributing and manufacturing driveway alarms for over 20 years. We have the experience necessary to meet your needs. Our product lines include Wireless Motion Drive Alerts, Wireless Rubber hose drive alerts, Vehicle Sensors, Weather Alert products and much more. Wireless Motion Alerts are very popular units because they are easy to install and will detect both vehicles and people walking. The radio operated drive alert consists of 2 parts - a transmitter and a receiver with 1 whistle. The receiver can be located in your house and plugged into a standard wall outlet. The weatherproof outside transmitter, operated by a 9 volt battery that normally lasts 6 months to 1 year, should be located in the area of your driveway. The transmitter sends out an invisible beam approximately 80 feet. The beam may be pointed in any direction since there is no reflector needed at the end of the beam. If a vehicle or person enters this area, the transmitter, which detects motion will send a radio signal up to 1000’* back to the receiver in the house. This sounds a small whistle for approximately 3 seconds to alert you and then shuts off automatically. In the event that you do not want the whistle to sound at any particular time, the receiver is equiped with an on-off switch.